Bespoke Object Revisted

 Here are some better pictures I have taken of the first iteration of the bespoke object.









My proposal is to revisit my bespoke object and make some improvements and modifications to the design. 

One of the significant issues I had with the first iteration of the design was that not all the pieces were cut with slots to fit into each other. This created a problem when trying to epoxy the pieces together; there was a lot of slipping around. This makes the surface look very messy, and I want to clean it up when I revisit the laser cut prep.

Another thing that needs to be improved is the design's lack of holes to allow for more weight distribution when it is hung from the ceiling. In the current design, there are only two holes, which means only two of the acrylic triangles support the weight of the entire piece. I would like to re-design the piece so that more than two pieces support its weight and make it more structurally sound.

When I originally wrote the proposal, I wanted to do two different prisms. I then had to cut this down to just the one prism as I was concerned about how much time I had left to complete the project, and I was worried about the amount of material I had versus what would have been required to complete the project. Now that I have done one version of the project, I will have enough material to do another version of the prism and complete the other piece that I had planned but could not laser cut. Below is the scale model for that prism.








Comments

Post a Comment

Popular posts from this blog

OBDF 311 - Proposal

Image
 For my first assignment on the bespoke object, I would like to create a laser-cut mirror prism as part of my drawing project. I want this piece to be a series of mirrors designed using CAD techniques and then laser-cut so they fit together and can be hung from the ceiling. This object is meant to act as a mirror or kaleidoscope in the center of the room, and the completed project will have projectors playing films at the object that reflect the colour back onto the wall. Essentially turning the entire room itself into one giant prism. The laser cutter is one tool needed to create this project. Physically, the piece will need some type of transparent wire that is strong enough to suspend it from the ceiling. Below are several rough sketches and the reference material used. I like aspects of all the designs. What I am prioritizing when choosing which design is ultimately how feasible it is to create in the time frame we have to work in and which object will be the most efficient at ...
Read more

Bespoke Object

Image
 This week, I assembled the pieces of the prism. There were some minor issues with epoxy getting stuck on the mirror's surface, which I did not want, but this residue was easy enough to remove with some isopropyl alcohol and a cotton swab. One of the most significant issues I had was that one piece was not slotted into the prism but instead glued onto the edge of another. I did not laser cut a slot for this piece to nestle into because I was worried about losing some reflections on the piece. This piece became such a pain in the assembly process that if I were to do this project again, I would prefer to lose whatever mirror section would be lost in favour of easier assembly. Another thing that I would have changed is the foil transfer paper. I like that this method has some patterning in a colour variation, and I also like that it is reflective and has a textured/ funhouse mirror look. The only thing that really bugs me about this method is that it does not stick very well, so ther...
Read more