Mug


 

Comments

Post a Comment

Popular posts from this blog

Bespoke Object Revisted

Image
 Here are some better pictures I have taken of the first iteration of the bespoke object. My proposal is to revisit my bespoke object and make some improvements and modifications to the design.  One of the significant issues I had with the first iteration of the design was that not all the pieces were cut with slots to fit into each other. This created a problem when trying to epoxy the pieces together; there was a lot of slipping around. This makes the surface look very messy, and I want to clean it up when I revisit the laser cut prep. Another thing that needs to be improved is the design's lack of holes to allow for more weight distribution when it is hung from the ceiling. In the current design, there are only two holes, which means only two of the acrylic triangles support the weight of the entire piece. I would like to re-design the piece so that more than two pieces support its weight and make it more structurally sound. When I originally wrote the proposal, I wanted to...
Read more

Bespoke Object

Image
 This week, I assembled the pieces of the prism. There were some minor issues with epoxy getting stuck on the mirror's surface, which I did not want, but this residue was easy enough to remove with some isopropyl alcohol and a cotton swab. One of the most significant issues I had was that one piece was not slotted into the prism but instead glued onto the edge of another. I did not laser cut a slot for this piece to nestle into because I was worried about losing some reflections on the piece. This piece became such a pain in the assembly process that if I were to do this project again, I would prefer to lose whatever mirror section would be lost in favour of easier assembly. Another thing that I would have changed is the foil transfer paper. I like that this method has some patterning in a colour variation, and I also like that it is reflective and has a textured/ funhouse mirror look. The only thing that really bugs me about this method is that it does not stick very well, so ther...
Read more

Bespoke Object Revisted

Image
 Prism #1 Prism #2 ***I will take better documentation photos tomorrow during round-table discussions and post them to the blog.*** I have finally finished the assembly of both of the prisms. The first prism was a real headache to assemble at times. Due to the laser cutter being down, it had damaged some of my material, so there are little stress fractures around the perimeter of some of the pieces. The real struggle was finding the little nuts and bolts to be used in the joinery. I went to them, but they were not of a size carried at retail. Several shops and they could only be ordered special. I eventually did get the screws, but they did not fit perfectly into the joinery pieces I had laser cut, but eventually, we did manage to get them to fit and slotted all of the acrylic slides. It looks much better without the epoxy holding all the mirrors together and is more structurally sound. I want to find a more reflective surface for the mirror's backside. However, the new prism desig...
Read more